Table of Contents
Advertisement
04 Driver support
Collision warning with Full Auto-brake and Pedestrian Detection*
Cause
The surface of the windshield in front of the camera is dirty or covered
with ice or snow.
Fog, heavy rain or snow is interfering with the function of the camera.
The surface of the windshield is clean but the message remains in the
display.
The surface between the inside of the windshield and the camera is
04
dirty.
Symbols and messages in the display
Symbol
Message
Collision Warning
Off
Collision Warning
Unavailable
Auto braking was
activated
Windscreen Sen-
sors blocked
*
168
Option/accessory, for more information, see Introduction.
Description
Collision Warning is switched off. This message is displayed when the engine is started and will disappear
after approx. 5 seconds. It can also be erased by pressing the OK button.
Collision Warning cannot be activated. This message is displayed when the driver attempts to activate the
function. It will disappear after approx. 5 seconds or can be erased by pressing the OK button.
Auto-braking has been active. This message can be erased by pressing the OK button.
The camera is temporarily not functioning. This message is displayed if the camera is obstructed by snow,
ice, dirt, etc., on the windshield. Clean the area of the windshield in front of the camera, see page 166 for
more information on the camera's limitations.
Action
Clean or clear the section of the windshield in front of the camera.
No action possible. Heavy precipitation may affect the function of the
camera.
Wait a short time. It may take several minutes for the camera to regis-
ter visibility.
Contact an authorized Volvo retailer or service technician to have this
surface cleaned.
Advertisement
Table of Contents
