Table of Contents
Advertisement
Preparation
Installing a lens
This unit is not provided with a lens.
A special C mount type lens with flange back of 28.0 mm
can be used with no adapter. To use a 1/2" bayonet
mount type lens, an optional adapter (GL-V62U) is
required.
Reference
For your reference, examples of lenses that can be used
with the adapter are listed in the table below.
1/2" bayonet mount type lens
Manufacturer
MSF10B
Fujinon
MSF75B
MS8X12B
MSF20B
MSF35B
Installing the camera control unit
The camera control unit is provided with screw holes on
its side panels to allow installation in an EIA 19" rack.
1.
Remove the screws securing the rubber feet and
detach the rubber feet (four positions).
2.
Install the inner members for the slide rails on the
side panels of this unit.
3.
Install the outer members for the slide rails on the
rack. Slide the unit into the rack.
Slide rails from the following manufacturer can be
used.
Model name
Manufacturer's name
C-305-20
Japan Acuride Co., Ltd.
• For information on the installation of the outer
members and rack, consult the slide rail manufac-
turer or your dealer.
GAIN
SHUTTER
CAMERA
20
Lens type
(when installing in a rack)
Slide length
508 mm (20')
CAMERA CONTROL UNIT DZ-VCA1U
WHITE BALANCE
MODE
MENU
PUSH OPEN
POWER
ON
I
OFF
O
• Consult your lens dealer for information on install-
ing and using your lens.
• Make sure the lens is screwed all the way in.
Otherwise, back focus cannot be obtained.
Inner member
6 screws with a diameter of 4 mm
and a length of less than 6 mm
56.6
3
t = 3 mm
9.8 mm
Screw hole size
Inner member
Inner member installation
6-M4
111.1
114.3
Inner member installation
hole position dimensions
(Unit: mm)
Advertisement
Table of Contents
