Mode Control Section - JVC DZ-VCA1SE Instructions Manual

Mode control section

1 SOURCE switch
CAMERA
POSI
[CAMERA]
Outputs signals from the camera to the monitor.
[BAR]
Outputs an internal colour bar signal from the unit to the
monitor.
[TEST SG]
Outputs an internal 100% WHITE square screen from
the unit to the monitor.
Use to adjust for 100% WHITE and the aspect ratio of
the monitor.
3 POSI/NEGA switch
CAMERA
[POSI]
Set to this position for ordinary operation.
[NEGA]
Outputs inverted red, blue and green signals from the
camera to the monitor.
MODE
BAR
TEST SG
FREEZE
NEGA
DATE & TIME
ON OFF
MODE
BAR
TEST SG
FREEZE
POSI NEGA
DATE & TIME
ON OFF
2 FREEZE button
CAMERA
POSI
Press the FREEZE button to engage the Field Still mode
and press it again to restore the normal mode.
The status is shown by the LED at the left of the
FREEZE button.
LED lit : Field still
LED extinguished : Normal use
4 DATE & TIME switch
CAMERA
POSI
[ON]
The date and time are shown in the upper right corner of
the screen.
[OFF]
The date and time are not shown.
MODE
BAR
TEST SG
FREEZE
NEGA
DATE & TIME
ON OFF
MODE
BAR
TEST SG
FREEZE
NEGA
DATE & TIME
ON OFF
17