DURKOPP ADLER 887 Instruction Manual page 42

3.2.2 Assembly of stand table top with the motor on the machine head (direct drive)
10 8 9 2
4
6
3 5 6 1 10
–
Turn the table top (1) upside down.
–
Screw the electric cable channel (2).
–
Screw the pedal position sensor (3).
–
Screw the electric cable clip (4).
–
Put the oil tank on (5) and slide it in the arrow direction (6) till the
relevant protrusions of the tank are seated on the recess contour.
Screw the tank.
–
Screw the drawer (7).
–
Pre-bore the holes for wood screws and screw the drive control
box (8).
–
Screw the sewing lamp transformer (9) – if there is any.
–
Mount the electric cables according to chapter 5 of this instruction.
–
Pre-bore the holes (10) for the wood screws and screw the stand
frame. Then turn the stand to normal position.
–
Mount the yarn stand (11) with bar orientation according to the
picture.
–
Insert the machine head support pin (12).
–
Screw the rubber hinge bottoms (13).
–
Insert the inclined bases (14) in the sockets of the recess corners.
–
Insert the rubber corners (15).
–
Remove the blind from the bushing (16).
–
Dismantle the knee lever (17) and slide it through the bushing (16)
according to the picture.
7
11
15
14
12
13
16
17