Adjusting the LCD Projector projection angle
Adjusting the LCD Projection angle of the LCD Projector.
When the projector is in the horizontal position, keystone
correction is unnecessary and a correct image can be viewed.
Using the simple stand
While lifting up the front of the
projector, pull down the simple stand
located underneath the unit.
Note
Pressing the trapezoid correction KEYSTONE button will detect
the opening and closing of the swinging stand and automatically
make a trapezoidal correction, however, a slight distortion may
sometimes remain due to the installation condition of the unit.
Caution:
Never pick the unit up by the simple stand.
Using the swivel stand
1
Slide the TIGHTEN Knob to
the LOOSEN position.
2
Adjust to the desired projection
angle. If necessary, you can also tilt
to the right or left.
3
Slide the TIGHTEN Knob to
the TIGHTEN position.
Previous
screen
FRONT
(Top view)
FRONT
(Top view)
41