Table of Contents
Advertisement
IOAPIC Function
This field is used to enable or disable the APIC (Advanced Programmable Interrupt
Controller). Due to compliance with PC2001 design guide, the system is able to run in
APIC mode. Enabling APIC mode will expand available IRQ resources for the system.
Settings: [Enabled], [Disabled].
MPS Table Version
This field allows you to select which MPS (Multi-Processor Specification) version to
be used for the operating system. You need to select the MPS version supported by
your operating system. To find out which version to use, consult the vendor of your
operating system. Settings: [1.4], [1.1].
Full Screen LOGO Display
This item enables you to show the company logo on the bootup screen. Settings are:
[Enabled]
[Disabled]
Boot Sequence
Press <Enter> and the following sub-menu appears.
1st/2nd/3rd Boot Device
These items allow you to set the sequence of boot devices where AMIBIOS attempts
to load the operating system.
MSI Reminds You...
Available settings for "1st/2nd/3rd Boot Device" vary depending on
the bootable devices you have installed. For example, if you did not
install a floppy drive, the setting "Floppy" will not show up.
Boot From Other Devices
Setting the option to [Yes] allows the system to try to boot from other devices if the
system fails to boot from the 1st/2nd/3rd boot device. Settings are: [Yes], [No].
Shows a still image (logo) on the full screen at boot.
Shows the POST messages at boot.
BIOS Setup
3-9
Hide quick links:
Advertisement
Table of Contents
