ADJUSTING THE DELPHI MECHANICAL INJECTION PUMP CONTROLS
B1HPOYDD
Engine cold :
- Check the fast idle speed.
- Ensure that the lever (9) is against its stop by pushing it in the direction of the arrow ('). If
not, adjust with the cable clamp (8), and then the sleeve tensioner (4).
Fast idle :
- Refer to the specifications on page : 182
Engine hot :
- Ensure that cable (7) is slack.
Engine stopped:
- Fully depress the accelerator pedal, check that the lever (5) is against its stop (3).
Residual output (Anti-stall))
- Insert a 4 mm thick shim at (a) between the lever (5) and the screw (6). - Set the engine
speed to 1500 ± 100 rpm using the stop screw (6).
Idling speed :
- 800
rpm using the screw (2) (Air conditioning + 50 rpm).
+0
-50
Engine deceleration : from 3000 rpm to ''0''.
- Deceleration too fast (tendency to stall) : Loosen (6) by a 1/4 turn.
- Deceleration too slow : tighten (6) by a 1/4 turn.
193
Engine : RHY
XSARA