Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
7. Insert the center pole pin through the center "O" ring and brass grommet; make sure that the pin is not caught
on any part of the tent top. Lift the top using the center pole and set pole at an angled position so the top is
completely off the ground.
8. Tie off the jump rope attached the center pole(s) location (eye level 5-6 feet).
9. Remove the drop cloth.
10. Lift the center poles into a vertical position.
11. Loosely install the side poles while tightening all corner ratchets until the corner poles are vertically straight.
Be sure to work your way around the tent, tightening and loosening ratchets until the perimeter of the tent is
taut. Make sure the center pole remains vertically straight; to do this corner ratchets may need to be adjusted.
12. Secure the side poles by tightening the ratchets at each location.
13. Roll excess ratchet straps and secure into the ratchet buckle.
14. The tent top should now be complete. If sidewalls are desired, unroll the sidewalls between the stakes and
the side poles around the perimeter of the tent. Starting at a side pole, clip the sidewall snap hooks to the rope
line that is attached to the tent top.
Sidewall Rope Tensioning: For new tents and during its life cycle, it may be necessary to tighten the sidewall
support rope that runs the perimeter of the tent top. After the tent has been set up and tensioned, locate the
corner where the sidewall rope starts and stops. Securely tie off one end of the rope. While pulling against the
tie-off point, work your way around the perimeter of the tent, pulling out any unnecessary rope slack. Tie off the
opposite end of the rope once reached.
40' x 80' Premiere I Series High Peak Pole Tent
www.GetTent.com / www.CelinaTent.com
© 2013 Celina Tent Inc.
PG.8
Advertisement
Table of Contents
