Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
3. Attach the Loop Strap (B) or ropes to the tent top; ratchet assemblies are standard on all Premiere 1 High Peak
Pole Tents:
Ratchets: Attach the loop strap (B) end to the metal "O" ring on the tent top and assemble the ratchet assem-
bly. Take the loop strap (B) attached to the tent and pull it through the reel bars slot of the Ratchet Buckle with
Loop Strap (A) attached to the stake (ratchet buckles needs to have handle facing upward at all time) and pull
the loop strap (B) back towards the tent approximately 1 ½ feet. Hold the strap at this point with one hand and
begin to crank the ratchet handle back and forth with the other hand until the reel bars have turned at least 2
times as this eliminates the chance of slippage.
Ropes: Attach the rope to the metal "O" ring on the tent top. Tie the other end of the rope to the stake using a Double Loop Clove Hitch Knot - Gripping the rope down
from the grommet in your left hand, take the opposite end and create two loops that overlap. Move the first loop (located on the bottom) so that it slightly overlaps
on top of the second; put loops over the stake through the center gap created by the overlapping loops. Pull tight with the excess rope. Repeat at all pole locations.
Ropes
4. The corner poles are now ready to be erected. Insert the pole pin through the metal "O" ring and the brass
grommet (Very Important: make sure the pin goes through both the 'O' ring and grommet; if done improperly
this may cause damage to the tent top). Set the corner pole vertically straight and tighten the ratchets to keep
the poles erect. Repeat at all 4 corners.
5. Tie off the jump rope attached at each pole location. This rope is used to keep the pole in place in the wind
so that the tent does not lift off the side pole pin. Secure the jump rope by pulling it six to twelve inches down
the pole, bringing it around the pole and then between the pole and the rope itself. Pull it back taut to create
tension on the vertical length. Now wrap the rope around the pole and vertical portion of the jump rope creating
a tight coil that keeps the rope from slipping up. On the last coil, pull the end of the rope through to tie it off.
(see diagram)
Step 2
Step 1
Step 4
Step 3
6. Assemble the center poles.
40' x 80' Premiere I Series High Peak Pole Tent
www.GetTent.com / www.CelinaTent.com
© 2013 Celina Tent Inc.
PG.7
Advertisement
Table of Contents
