Receive Frequency; Rx Bcl And Tone Code - RELM PM4500 Instruction Manual

a. To delete the channel at this time,
press DELETE. The display will show:
Blinking - I
Press ENTER to answer Yes.
NOTE: To answer No, press TOGGLE or any
diait kev.
See page 24 for display sequence of a
deleted channel.
NOTE: If you make an error in number entry, start
over by pressing CHANNEL and the correct
number.
b. To step to Receive Frequency, press
ENTER.

3. Receive Frequency

Display will show, for the VHF models, one of
the following:
if previously programmed
or, if none is programmed
For UHF models, the display will show one of the
following:
if previously
Blinking
or, if none is programmed
4. Key in the six digits of the desired RX frequency.
The valid frequency range is between 150 and
174 MHz for VHF models and between 450 and
482 MHz for UHF models.
Examples of keyed in frequencies:
56045 (158.045 MHz; VHF models)
167237 (167.2375 MHz; VHF models)
470012 (470.0125 MHz; UHF models)
NOTE: Ignore the decimal.
If an error is made in entering the digits, press
DELETE and start over.
Press ENTER to store the Receive Frequency in
the Transceiver's memory. The display will advance
to RX BCL and Tone Code.

5. RX BCL and Tone Code

Display will show, for example:
programmed
1 5
BCL Code