Message Annunciator; Talk Around; Range - RELM PM4500 Instruction Manual

15. Power Up on Channel 1.
The display will show one of the following:
Blinking 2
Blinking 3'
TOGGLE
16. Press key to toggle Y (Yes) to N (No)
or vice versa. If Yes is selected, the Radio will
always be on Channel 1 whenever it is turned
ON (powered-up). If it was in the MANUAL Mode
on Channel 13 (for example) when turned OFF, it
will power-up on Channel 1. If it was in the SCAN
Mode when turned OFF, it will power-up in the
SCAN Mode and start scanning.
ENTER
Press to store in memory and advance
the display to TX Carrler Delay.
17. TX Carrier Delay.
Display will show, for example:
Blinking 1
18. Enter a value 0, 1, 2 or 3. (See Table 3, below.)
TX Carrier Dleay is the amount of time the carrier
(no modulation) is still present afferthe Pll
switch is released.
Table 3. Delay Values (mS).
Numeral Delay
0 165
3 0 0
1
Press ENTER to store in memory and advance
the display to Message Annunciator.
10
Numeral Delay
2 4 0 0
3 5 0 0

19. Message Annunciator.

The display will show one of the following:
20. TOGGLE
Press key to ON or OFF. If ON is
selected, the Message Annunciator feature is
enabled. If OFF is selected, the Message An-
nunciator feature is disabled.
Press ENTER to store in memory and advance
the display to Talk Around.

21. Talk Around.

The display will show one of the following:
Blinking 2
Blinking
22. TOGGLE
Press key to toggle Y (Yes) to N (No)
or vice versa.
Press ENTER to store in memory and advance
the display to Range.

23. Range.

The display will show, for example: