Configurations - Teledyne 2105 Installation And Operation Manual

5.3 Configurations

Figure 5-1 Configuration example (direct connection shown)
Section 5 Modbus Protocol and 2100 Output
Each module capable of Modbus Protocol communication will
automatically create its own specific ASCII address within the
site, using:
• The model numbers of the modules
• The user-defined module names
A variety of configurations can be made with Modbus, either
through direct connection or through a modem.
In the example shown in Figure 5-1, you are direct-connecting a
server PC to two individual 2100 sites through Modbus, using
the COM ports on the OPC Server, which are directly connected
to the remote sites.
Connection to the module is made through the RS-232 communi-
cation port on the top of the module.
Note
For low power operation, we recommend connecting the mod-
ule(s) to the computer using the straight-through cable (Isco
part number 60-5314-529), which consumes less power,
instead of our standard interrogation cable.
In Figure 5-1, the OPC Server PC must have two COM ports.
Modbus requires one COM port each, for direct connection of
each site.
2150
2150
2105 Interface Module
COM
port 1
OPC
Server
COM
port 2
Process
Control
5-3