Nvram Option Setting - Samsung SV-7000W Service Manual

6-5 NVRAM Option Setting

1) NVRAM Option is adjusted at production line basically.
2) In case Micom (IC601) and NVRAM (IC605 ; EEPROM) is replaced, be sure to set the corresponding option number of the repaired
model. (If the option is not set, the unit is not operated.)
1) Press the ÒTESTÓ (SV-7000W ; SW711, SV-5000W ; SW718) button on Timer PCB to set the adjustment
mode. (See Fig. 6-2)
2) Press the ÒMENUÓ button on the remote control about 5 seconds then option setting display is appeared.
(See Fig. 6-5)
3) Select the option number (See Table 6-1) of corresponding model with Ò
control.
4) If selecting the option number is completed, press the Ò
(If ÒSTOPÓ button is pressed, the selected number is changes reversed color. ; See Fig. 6-5)
5) Press the ÒOKÓ button of remote control again to store the option number.
(ÒPLEASE WAITÓ is displayed for a second as shown Fig. 6-6 and this setting is completed.)
6) Turn the Power off.
OPTION DIODE
**
01 02 03 04
09 10 11 12 13 14 15 16
17 18 19 20 21 22 23 24
25 26 27 28 29 30 31 32
33 34 35 36 37 38 39 40
41 42 43 44 45 46 47 48
CNG :
MODELS TV SYSTEM
SV-7000W
SV-5000W
Samsung Electronics
**
05 06 07 08
SAVE : OK
Fig. 6-5
<Table 6-1>
OPTION NUMBER
NTSC/PAL 1, 2, 3, 4, 5, 6, 9, 10, 11, 13, 14, 15, 16
NTSC 1, 2, 3, 4, 6, 8, 13, 14, 15
PAL 1, 2, 3, 4, 5, 9, 10, 11, 13, 14, 15
Ò and Ò
Ó button of remote control.
OPTION DIODE
**
01 02 03 04
09 10 11 12 13 14 15 16
17 18 19 20 21 22 23 24
25 26 27 28 29 30 31 32
33 34 35 36 37 38 39 40
41 42 43 44 45 46 47 48
PLEASE WAIT
CNG :
Alignment and Adjustment
Ò button on the remote
**
05 06 07 08
SAVE : OK
Fig. 6-6
6-5