Downloading The Firmware From The Memory Card - Kyocera FS-1350DN Service Manual

2H4

(3) Downloading the firmware from the memory card

To download data written in a memory card (CompactFlash) to the printer, proceed as explained in this section.
CAUTION
Downloading firmware takes several minutes. Do not turn power off during downloading. If downloading is interrupted by
an accidental power failure, etc., the control PWB may have to be replaced.
Procedure
1. Turn printer power off.
2. Open the rear cover.
3. Remove two screws and then remove the
optional interface slot cover.
4. Insert the memory card into the memory
card slot.
5. Turn printer power on.
6. Press MENU key on the printer's operation
panel and carry out the memory card for-
matting procedure (1).
7. When formatting is complete, turn printer
power off.
1-6-4
Figure 1-6-5
Message display
Ready
Press MENU key. Press arrow key.
>Memory Card
Press arrow key.
>>Format
Press OK key.
(1)
>>Format ?
Press OK key.
Processing
(Format information is
automatically printed.)
Ready
Figure 1-6-6
Memory card slot
Memory card
Optional interface
slot cover
Operation panel key
>
Press arrow key.
Screw
Screw