Table of Contents
Advertisement
Installing batteries
Putting batteries in the remote control
The battery compartment is located on the back of the remote control.
1. Press down on the triangular mark of the compartment cover,
and slide the cover off to open the compartment.
2. Place the two accessory R03 (UM-4)/AAA (24F) batteries in
the remote control according to the polarity markings ("+" and
"–") inside the compartment and on the batteries.
3. Place the cover over the compartment, press down lightly, and
push it upward until it snaps on.
The batteries last about one year with normal use. If function of the
remote control become erratic, replace the batteries. See "Precautions
for the safe use of batteries" below for more information.
BEFORE USING FOR THE FIRST TIME
Precautions for the safe use of batteries
Observe the following precautions for the safe use of batteries. Their
life will be shortened, they may burst or their contents may leak if they
are used improperly:
•
Remove batteries from the remote control if it is not going to be used
for a long period of time.
•
Remove dead batteries and dispose of them properly.
•
Never leave dead batteries lying around, take them apart, mix them
with other refuse, or throw them into an incinerator.
•
Never touch liquid that has leaked out of a battery.
•
Do not mix new and old batteries, or batteries of different types,
when replacing them.
Page 3
Advertisement
Table of Contents
