Installing Batteries; Putting Batteries In The Remote Control - JVC LET0088-001A Instruction Manual

Installing batteries

Putting batteries in the remote control

The battery compartment is located on the back of the remote control.
1. Insert a finger in the recess under the battery compartment
cover, and pull off the cover.
2. Place the two accessory R6P (SUM-3)/AA (15F) batteries in
the remote control according to the polarity markings ("+" and
"–") inside the compartment and on the batteries.
3. Insert the two tabs of the cover in their respective slots, and
snap the cover in place.
The batteries last about one year with normal use. If function of the
remote control become erratic, replace the batteries.
Precautions for the safe use of batteries
Observe the following precautions for the safe use of batteries. Their
life will be shortened, they may burst or their contents may leak if they
are used improperly.
BEFORE USING FOR THE FIRST TIME
• Remove batteries from the remote control if it is not going to be used
for a long period of time.
• Remove dead batteries and dispose of them properly.
• Never leave dead batteries lying around, take them apart, mix them
with other refuse, or throw them into an incinerator.
• Never touch liquid that has leaked out of a battery.
• Do not mix new and old batteries, or batteries of different types,
when replacing them.
Page 3