Table of Contents
Advertisement
USER MANUAL
8.4. Cleaning of the glass
The glass has a self-cleaning function, which means when the
fireplace is activated, air flows over its surface in order to
prevent the storage of ash and slug on it. Despite this fact,
after a few hours of heating the glass becomes darker. It is
necessary to remove the dark mantle off the glass before you
activate the fireplace again. While you clean the glass you
should check if the sealing joint at the borders of the glass is
in good condition. A bad condition of the sealing joint could
cause problems connected with the functioning of the
fireplace.
8.5. Exchange of door glass
The fireplace is equipped with ceramic glass, 4 mm of
thickness, that resists a thermal shock of 750 degrees of
Celsius. It could only be broken by a hard beat or inadequate
handling of the fireplace.
Do not slam the fireplace door or hit it. In case of broken glass
contact our service or your distributor.
8.6. Annual maintenance/cleaning
Following steps need to be done during annual cleaning of
the fireplace:
34
www.kovan.ba
Advertisement
Table of Contents
