Pulley - Ariens 815034 Owner/Operator's Manual & Parts List

Install PTO Belt (Figure 10)
1. Install PTO belt (item 7) on electric clutch pulley
and snow thrower pulley.
Snow Thrower

Pulley

Idler Pulley
Install Snow Thrower Wire Harness
(Figure 11)
WARNING: Avoid Electric Shock. Objects
contacting both battery terminals at the same
time may result in injury and unit damage. DO
NOT reverse battery connections.
Explosive Gases from battery can cause death
or serious injury. Poisonous battery fluid
contains sulfuric acid and its contact with skin,
eyes or clothing can cause severe chemical
burns.
WARNING: NO flames, NO sparks, NO smoking
near battery.
1. Lift up seat.
2. Disconnect negative battery cable.
3. Disconnect headlight wire harness from main wire
harness.
4. Place headlight wire harness off to the side.
5. Route snow thrower wire harness along the frame.
IMPORTANT: Make sure the harness is clear of all pinch
points, hot surfaces or rotating parts that can damage the
wires.
6. Connect the snow thrower wire harness to the unit's
main wire harness, blue wire to blue wire, black
wire to black wire.
7. Connect negative battery cable.
8. Put the seat down.
7
Electric Clutch
Pulley
Figure 10
OEe022
Snow Thrower
Wire Harness
GB - 12
Main Wire
Headlight
Harness
Wire
Harness
Route Snow Thrower Wire
Harness Along the Frame
Figure 11
OEe023