Kenwood KDC-MP6025 Service Manual page 12

KDC-MP6025/MP625/MP858
KDC-W6527/W6527Y
Audio Related Matters
• When [Q] key is pressed intermittently, audio adjust mode
is entered.
• With [ ] key on the remote controller, audio adjust mode is
entered.
• The initial item is Fader.
• Continuous feed with the remote controller is prohibited.
• The Bass/Middle/Treble levels are adjusted using
keys on three levels: -8 ↔ 0 ↔ +8. (Initial value: 0)
• Balance is adjusted using
L15 ↔ 0 ↔ R15. (Initial value: 0)
• Fader is adjusted using
↔ 0 ↔ F15. (Initial value: 0)
• Sub Woofer level is adjusted using
levels: -15 ↔ 0 ↔ +15. (Initial value: 0)
• Volume Offset is adjusted using
els: -8 ↔ 0. (Initial value: 0)
• HPF is adjusted using
↔ 170Hz (or 220Hz). (Initial value: Through)
• LPF is adjusted using
↔ Through. (Initial value: Through)
• Bass f / Bass Q / Bass EXT / Middle f / Middle Q / Treble f is
not displayed on Audio Adjust.
• [WOW] key feeding works in the following order: q → w →
e → r → t → y → q
Value Setting
Order
TruBass FOCUS
q
OFF OFF
w
ON OFF
e
OFF Low
r
OFF High
t
OFF OFF
y
ON High
MENU Related Matters
• When [MENU] key is pressed intermittently, MENU is en-
tered.
• Using [DNPP/SBF] key on the remote controller, MENU is
entered.
• Continuous feed with the remote controller is prohibited.
12
TEST MODE
/
/ keys on three levels:
/ keys on three levels: R15
/ keys on three
/ keys on two lev-
/ keys on two levels: Through
/ keys on two levels: 50Hz
Display
SRS 3D
OFF SRS WOW OFF
OFF SRS TruBass ON
OFF FOCUS LOW
OFF FOCUS HIGH
ON SRS 3D ON
ON SRS WOW HIGH
Backup Current Measurement
When reset in the Acc OFF (Back Up ON) condition, MUTE
terminal goes off in 2 seconds instead of 15 seconds. (When
this takes place, CD/MD mechanisms will not be in opera-
tion.)
Special Display when All Lamps are Lighted Up
When all lamps are lighted up during STANDBY, the follow-
ing displays will be made by pressing the pre-set key.
[1] key Version Display
(Display) SYS_x.xx
PAN_x.xx
[2] key Serial number display (8 digits)
(Display) SNo_xxxxxxxx
[3] key Single Push: Displays Power ON time
During Power ON time display, pressing the key two
(2) seconds will clear Power ON time.
(Display) PonTim_0xxxxx
[4] key Single Push: Hours CD/MD in operation.
During CD/MD operation time display, pressing the
key two (2) seconds will clear CD/MD operation time.
(Display) CDTim_0xxxxx / MDTim_0xxxxx
[5] key Single Push: Number of CD/MD EJECT times will be
displayed.
During CD/MD EJECT time display, pressing the key
two (2) seconds will clear CD/MD EJECT times.
(Display) EjeCnt__0xxxxx
[6] key Single Push: Number of PANEL open/close times (*1)
During PANEL open/close times display, pressing the
key two (2) seconds will clear PANEL open/close times.
(Display) PnCnt_xxxxxx
[FM] key ROM Correction Version Display
(Display) SYS_ROM_Rxxx
When N/A: SYS_ROM_R – – –
(Display) PAN_ROM_Rxxx
When N/A: PAN_ROM_R – – –
key AUDIO data initial value setting
(Display) AUDIO_INIT
*1 : One count is made when panel is full open or at disc loading.
MAX 65535 (Hours)
MAX 65535 (Hours)
MAX 65535 (Times)
MAX 65535 (Times)