Table of Contents
Advertisement
1210-7201-01(i12010S)_V3.qxd:_
2014.2.20
3:19 PM
Page
Installation Instructions
Step 1
Installation Guide:
IMPORTANT: THIS ALARM MUST BE MOUNTED ON A
CEILING OR WALL. IT WAS NOT DESIGNED FOR USE AS A
TABLETOP DEVICE! INSTALL ONLY AS DETAILED!
A. Recommended Installation Locations:
Kidde Safety recommends the installation of a Smoke Alarm in
the following locations. For maximum protection we suggest an
alarm be installed on each level of a multilevel home, including
every bedroom, hallways, finished attics and basements. Put
alarms at both ends of bedroom, hallway or large room if hallway
or room is more than 30 ft (9.1m) long. If you have only one
alarm, ensure it is placed in the hallway outside of the main
sleeping area, or in the main bedroom. Verify the alarm can be
heard in all sleeping areas.
Locate an alarm in every room where someone sleeps with the
door closed. The closed door may prevent an alarm not located
in that room from waking the sleeper. Smoke, heat and
combustion products rise to the ceiling and spread horizontally.
Mounting the alarm on the ceiling in the center of the room
places it closest to all points in the room. Ceiling mounting is
preferred in ordinary
residential construction.
When
mounting
an
alarm on the ceiling,
locate it at a minimum
of 4" (10cm) from the
side wall (see figure 1).
If installing the alarm on
the wall, use an inside
wall with the top edge of
the alarm at a minimum
of 4" (10cm) and a
maximum
of
12"
(30.5cm)
below
the
ceiling (see figure 1).
FIGURE 1
6
Hide quick links:
Advertisement
Table of Contents
