Raymarine SR6 Installation Manual page 25

3. Make the antenna, audio and SeaTalk
the unit. Pass the cables through the appropriate grommets.
• Connect the audio and antenna cables first. These are below
the network connectors and it is easier to connect the antenna
and audio first.
• Antenna and audio should be passed through the same
grommet. (Use the 1 or 2 hole grommet depending upon the
connections required).
• Use a blanking grommet for any unused connections.
Installation
D11914-1
hs cable connections into
4. Connect the unit to the power supply using the hard wired lead.
5. Replace the bottom panel, taking care with the rubber seal, and
replace the three screws.
6. Secure the SR6 unit in place using the 2 self tapping screws
provided.
After installation you will need to activate your Sirius receiver for use
with the Sirius subscription service.
D11913-1
25