www.reelschematic.com
ON
OFF
000977
EMU01874*
Procedure
1) To remove the cowling: depress the
lock-lever at the rear of the cowling, and
lift the cowling up and backward.
2) To remove the flywheel cover: pull out
the lock pin, loosen the bolt, and then
remove the flywheel cover.
3) Lock the front panel with the lock pin.
208032
4) Prepare the engine for starting. See
STARTING ENGINE for procedures. Be
sure the engine is in neutral and that
the lanyard is attached to the engine
stop switch. The main switch must be
on if the main switch is equipped on the
electric start model.
NOTE:
Refer to "ENGINE FAILS TO OPERATE" for
cold engine starting procedures.
5) To start the engine with the emergency
starter rope, insert the knotted end of
the rope into the notch in the flywheel
rotor and wind the rope several turns
clockwise. Then give a strong pull
straight out to crank the engine. Repeat
if necessary.
208033
E
5-6