Head Lamp Bulb Replacement - TATA Motors 2013 SAFARI STORME Owner's Manual & Service Book

IN CASE OF EMERGENCY

HEAD LAMP BULB REPLACEMENT :

Procedure:
WARNING
• Bulbs can be very hot. You should
therefore allow them to cool down
before you change them.
• Keep bulbs out of reach of children.
• Never use a bulb which has been
dropped. Such a bulb may explode
and injure you.
• Do not touch or handle bulbs with
bare hand
Before you change the bulb :
• Only fit bulbs of the same type and
wattage.
• Switch the lights OFF before changing
a bulb to prevent short circuit.
• Always hold the bulb with a clean, lint
free cloth.
• Do not work with wet or greasy fingers.
• If the new bulb does not come ON,
contact the nearest TATA authorized
service centre.
108
• Handle the bulb only at metal part and
not at glass portion.
High beam bulb replacement :
1. Open the bonnet.
2. Remove the rubber cap / socket cover
on the backside of the headlamp.
3. Disconnect the electrical connector by
pulling it out firmly.
4. Loosen the screw to release the bulb
retainer spring, which holds the bulb.
Release bulb by pressing and moving
it upward.
HEAD LAMP BULB REPLACEMENT
5. Remove the defective headlamp bulb
carefully.
6. Fit the bulb by following the above
steps in reverse order.