Sony AIR-SA10 Service Manual page 9

3-6. REG BOARD, POWER TRANSFORMER (PT901), POWER CORD
four screws
(BVTP3 × 10)
POWER board
Remove the solder.
Cut two cables tie.
Remove a solder.
(cable: white)
Remove a solder.
(cable: black)
Note: When installing the power code,
note the color of cable.
3-7. AMP BOARD, LCD BOARD
Note: This illustration is seeing front panel block from the inside.
REG board
power
transformer
(PT901)
four screws
(BVTP3 × 10)
ferrite core
AC HOLDER board
coating clip
screw
(BVTP3 × 10)
LCD board
three screws
(BVTP2.6)
AMP board
AIR-SA10
power cord
four screws
(BVTP2.6)
9