Antenna Aiming; Memory Options - JVC KT-SR2000 Instructions Manual

8 Antenna Aiming

This is required to be adjusted only when you use
your JVC PnP at home.
You can ensure optimum reception when locating the
SIRIUS antenna.
Upon entering this mode, two horizontal bar graphs
are displayed.
The satellite signal strength level is displayed on the
SAT graph while the terrestrial signal strength level is
displayed on the TER graph. The current reception
levels are shown on the graphs.
Move the antenna location so that the level indication
on the bar graph moves as close to the right end as
possible.
To exit this option, press MENU or SEL (or SELECT).
Note: Terrestrial repeaters are typically used in
large urban areas where satellite signal reception
is not stable.
• Terrestrial signals (TER) may not be available in
your residential area.

9 Memory Options

You can activate or deactivate S-Seek Function. In
addition, you can delete all stored PDT (see page 21)
at a time.
The following adjustments are possible on this sub-
menu screen—"Automatic Memory Search" and
"Clear All Memory".
Automatic Memory Search: Press CH 5 / ∞ (or CH
+ / –) to select either "On" or "Off", then press SEL
(or SELECT).
• On: To activate the S-Seek Function.
• Off: To deactivate the S-Seek Function.
Clear All Memory: Press CH 5 / ∞ (or CH + / –) to
select either "Yes" or "No", then press SEL (or
SELECT).
• Yes: To erase all stored PDTs.
• No: To cancel the erasure.
27