Kenwood DNN991HD Quick Start Manual page 24

Ñ Connecting wires to terminals
Ignition key
switch
ACC
Car fuse box
Car fuse box
(Main fuse)
A
Battery
To use the steering wheel remote control
feature, you need an exclusive remote
adapter (not supplied) matched to your car.
To car light control switch
Connect to the terminal that is grounded
when either the telephone rings or during
To use the Mute feature, you need to hook
up this wire to your telephone by using a
commercial telephone accessory.
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for
the booster amplifier
of the film-type antenna. (Max. 300mA, 12V)
When using the optional power amplifier,
connect to its power control terminal.
24
ñ English
HDMI/MHL
MIC AV-IN/OUT
AV-OUT
AUDIO
R
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire) ¤
(To car chassis)
A
Light Blue/Yellow
(Steering remote control wire)
To steering remote
conversation.
M4 x 8mmMAX
GPS
iDalalink
iPod/
AV-IN2
PTT
EXT
I/F
L
Accessory 1
REMOTE STEERING
CONT WHEEL
REMOTE
INPUT
Orange/White (Dimmer
control wire)
ILLUMI
Brown (Mute control wire)
MUTE
Blue
(Antenna control wire)
ANT CONT
Blue/White
(Power control wire)
P. CONT
If no connections are made,
do not let the cable come out from the tab.
I/F
POWER
Speaker impedance: 4-8 Ω
White/Black
+
White
Gray/Black
+
Gray
Green/Black
+
Green
Purple/Black
+
Purple
To front left
speaker
To front right
speaker
To rear left
speaker
To rear right
speaker