Oven Control Board - Wolf Wall Ovens Technical & Service Manual

Component Access and Removal
W W a a l l l l O O v v e e n n s s
Oven Controller Removal
The oven control board is located next to the control
panel drive motor assembly. Remove all wire connec-
tors mounted to the control board.
NOTE: You may want to mark the wire connectors to
ensure their proper location when reattaching to the
board.
Now, extract the four screws that secure the control
board and lift out. (See Figure 4-13).
Stepper Motor Control Board Removal
Extract the screws that secure the oven control board to
Figure 4-13. Oven Control Board Removal.
the mounting plate. (See Figure 4-14). Now, lift the
board up slightly (where the screw was located) and
slide the board towards the center unit. Doing this will
release the board mounting tabs from the mounting
plate. Next, remove all of the wire connectors from the
board and remove. (See Figure 4-15).
NOTE: You may want to mark the location of the wiring
to ensure proper placement when reassembling.
Figure 4-14. Stepper Motor Screw Removal>
Figure 4-15. Stepper Motor Removal.
4-6