JVC RX-7022VSL Instructions Manual page 30

Creating Realistic Sound Fields
3
Press SOUND.
The 10 keys are activated for sound adjustments.
4
Press TEST to check if you can hear
the sounds through all the speakers at
the equal level.
"TEST TONE L" starts flashing on the display and a test tone
comes out of the speakers in the following order:
TEST TONE L TEST TONE C
(Left front speaker) (Center speaker)
TEST TONE LS
(Left rear speaker)
Notes:
• You can adjust the speaker output levels without outputting the
test tone.
• No test tone comes out of the center speaker when "CNTR SP"
is set to "NONE."
• No test tone comes out of the rear speakers when "REAR SP"
is set to "NONE."
5
Adjust the speaker output levels (–10 to +10).
Adjust the center speaker and rear speakers levels comparing to
the sound from the front speakers.
• To adjust the center speaker level, press
CENTER +/–.
• To adjust the left rear speaker level, press
REAR•L +/–.
• To adjust the right rear speaker level, press
REAR•R +/–.
6
Press TEST again to stop the test
tone.
27
On the front panel:
SOUND
You can also use the buttons on the front panel to adjust the
Surround modes. However, no test tone is available when using the
buttons on the front panel. So make adjustments while listening to
TEST
the sound of the source played back.
4
1
TEST TONE R
(Right front speaker)
2
TEST TONE RS
(Right rear speaker)
If you like to adjust sound, go to step 3 .
– CENTER +
2 3
3
MENU
– REAR • L +
5 6
ENTER
ENTER
– REAR • R +
8 9
TEST
4
Setting the analog or digital input mode for the
source you like to hear and start playing.
When playing back software encoded with Dolby Digital and DTS
Digital Surround, select the digital input mode (see page 15).
Press SURROUND ON/OFF to
activate Surround mode.
Each time you press the button, Surround
mode turns on and off alternately.
• If you are playing back software encoded with Dolby Digital
multichannel, "DOLBY DIGITAL" is selected.
• If you are playing back software encoded with DTS Digital
Surround, "DTS SURROUND" is selected.
• If you are playing back any software other
than above, you can select "PL II MUSIC"
or "PL II MOVIE" according to the source
by pressing SURROUND MODE. (
LOGIC II indicator lights up on the display.)
Adjust the speaker output levels.
1) Press ADJUST repeatedly until one
of the following indications (with the
current setting)* appears on the
display.
SPK 1
PRO LOGIC ΙΙ
DIGITAL AUTO L C R
DSP H.PHONE
S.WFR LFE
LINEAR PCM
LS S RS
* "0" is the initial setting. If you have already changed the
setting, another number (level) will be shown.
CENTER : To adjust the center speaker output level
(–10 to +10).
REAR L : To adjust the left rear speaker output level
(–10 to +10).
REAR R : To adjust the right rear speaker output level
(–10 to +10).
2) Press CONTROL UP 5/
DOWN ∞ to adjust the selected
speaker output levels.
3) Repeat steps 1) and 2) to adjust the other
speaker levels.
SURROUND ON/OFF
SURROUND MODE
PRO
ADJUST SETTING
TUNED STEREO AUTO MUTING
VOLUME
INPUT ATT
CONTROL
DOWN UP