Connecting The Power Cord - JVC RX-7022VSL Instructions Manual

Getting Started
Digital connections
This receiver is equipped with four DIGITAL IN terminals—one
digital coaxial terminal and three digital optical terminals, and one
DIGITAL OUT terminal.
You can connect any digital equipments such as—:
• DBS tuner,
• Digital TV broadcast tuner,
• DVD player,
• CD player, and
• CD recorder.
IMPORTANT:
• When connecting the DVD player, digital TV broadcast tuner or DBS
tuner using the digital terminals, you also need to connect it to the
video jack on the rear. Without connecting it to the video jack, you
can view no playback picture.
• After connecting the components using the DIGITAL IN terminals,
set the following correctly if necessary:
– Set the digital input (DIGITAL IN) terminal setting correctly. For
details, see "Setting the Digital Input (DIGITAL IN) Terminals" on
page 14.
– Select the digital input mode correctly. For details, see "Selecting
the Analog or Digital Input Mode" on page 15.
Digital input terminals
Digital TV
CD player
Digital coaxial cable (not supplied)
between digital coaxial terminals
Digital optical cable (not supplied)
between digital optical terminals
When the component has a digital
coaxial output terminal, connect it to the
DIGITAL 1 (DVD) terminal, using the
digital coaxial cable (not supplied).
When the component has a digital
optical output terminal, connect it to the
DIGITAL 2 (CD), DIGITAL 3 (TV), or
DIGITAL 4 (CDR) terminal, using the
digital optical cable (not supplied).
Before connecting a digital
optical cable, unplug the
protective plug.
9
Notes:
• When shipped from the factory, the DIGITAL IN terminals have
been set for use with the following components:
– DIGITAL 1 (coaxial): For DVD player
– DIGITAL 2 (optical): For CD player
– DIGITAL 3 (optical): For digital TV broadcast tuner
– DIGITAL 4 (optical): For CD recorder
• When you want to operate the CD player or CD recorder using the
COMPU LINK remote control system, connect the target
component also as described in "Analog connections" (see page 7).
• When you want to operate the DVD player using the AV COMPU
LINK remote control system, connect the DVD player also as
described in "Analog connections" (see page 8).
Digital output terminal
This terminal can output the same type of incoming signals Dolby
Digital, Linear PCM, and DTS.
DBS tuner
DBS
DVD player
DVD
CD recorder

Connecting the Power Cord

Before plugging the receiver into an AC outlet, make sure that all
connections have been made.
Plug the power cord into an AC outlet.
Keep the power cord away from the connecting cables and the
antenna. The power cord may cause noise or screen interference. We
recommend that you use a coaxial cable to connect the antenna,
since it is well-shielded against interference.
DIGITAL 1
(DVD)
CAUTIONS:
• Do not plug in before setting the voltage selector switch on the rear
of the unit and all connection procedures are completed.
DIGITAL 2 ( CD )
• Do not touch the power cord with wet hands.
• Do not pull on the power cord to unplug the cord. When unplugging
the cord, always grasp the plug so as not to damage the cord.
DIGITAL 3 ( TV )
DIGITAL 4 (CDR)
DOLBY DIGITAL
/PCM
/DTS
DIGITAL IN
CD recorder, etc.
Digital optical cable (not supplied)
between digital optical terminals
When the digital recording
equipment such as a CD recorder
has a digital optical input terminal,
connect it to the DIGITAL OUT
terminal enables you to perform
digital-to-digital recording.
DOLBY DIGITAL/PCM
/DTS
DIGITAL OUT