Dell SuperMassive 9200 Getting Started Manual page 16

The following sections provide initial configuration information
and instructions for connecting your Dell SonicWALL
SuperMassive 9200 appliance for initial setup.
• Connecting the MGMT Port, page 15
• Applying Power to the SuperMassive 9200, page 15
• SuperMassive 9200 LED Activity, page 15
• To access the SonicOS management interface, follow the
steps listed:, page 16
Connecting the MGMT Port
1. Using the provided Ethernet cable, connect one end of the
cable to the computer you are using to manage the
Dell SonicWALL SuperMassive appliance.
2. Connect the other end of the Ethernet cable to the MGMT
port on your Dell SonicWALL SuperMassive appliance.
Applying Power to the SuperMassive 9200
Connect the AC power cords from the Dell SonicWALL
SuperMassive appliance into appropriate power outlets.
For further information regarding power requirements, refer to
Product Safety and Regulatory Information, page 57
document.
SuperMassive 9200 LED Activity
The Power LEDs on the front panel illuminate blue when the
appliance is powered on.
The Test LED or Alarm LED may illuminate and blink while the
appliance performs a series of diagnostic tests. When these
LEDs are no longer illuminated and the Power LEDs remain
steadily lit, the Dell SonicWALL SuperMassive 9200 appliance
is ready for configuration. This typically occurs within a few
minutes of turning on the power.
If the Test or Alarm LEDs remain lit after the
SuperMassive 9200 has completed powering on, restart the
appliance by disconnecting the power, waiting 1 minute, then
connecting the power again.
For a connected MGMT or X0 - X7 port, the Link LED for the
port illuminates green or amber depending on the link
throughput speed, indicating an active connection:
• Amber indicates 1 Gbps
• Green indicates 100 Mbps
• A unlit left LED with the right LED lit indicates 10 Mbps
in this
Initial Setup | 15