Unpacking; Loose Parts List - QEP TILE SAW 60707 Instruction Manual

supply (±10% AC 230V), the rotational
speed of the spindle will never exceed the
rated no-load speed.
Grounding
In the event of an electrical short circuit,
grounding reduces the risk of electric shock by
providing a path of least resistance to disperse
electric current. This machine is equipped with
a power cord having an equipment-grounding
prong
1. Reduce the risk of electrocution by
keeping all connections dry and off the
WARNING! To prevent accidental starting that
could cause possible serious personal injury,
assemble all parts to your tile cutter before
connecting it to power supply. Tile cutter
should never be connected to power supply
when you are assembling parts, making
adjustments, installing or removing blades, or
when not in use.
 Carefully remove all parts from the carton
and place the tile cutter on a level work
surface. Separate and check against the
list of loose parts.
Check all loose parts from the box with the list below. Assemble according to the instruction on the
following pages.
Water tank.............................................1
Spanner A..............................................1
Spanner B..............................................1
Riving knife.............................................1
Blade guard............................................1
Parallel guide.......................................1
180mm Continuous rim diamond blade.......1
Miter gauge............................................1
2. This machine must have a ground prong

UNPACKING

WARNING! If any parts are missing, do not
operate this tool until the missing parts are
replaced. Failure to do so could result in
possible serious you new tile cutter.

Note: If any parts are damaged or missing, do
not attempt to plug in the power cord and turn
the switch on until the damaged or missing
parts are obtained and are installed correctly.

LOOSE PARTS LIST

Instruction manual (not shown)..................1
- 7 -
ground. Do not touch plugs with wet hands.
Failure to follow these warning could result
in serious injuries.
in the plug to help ensure that it is
grounded. Do not remove ground prong
from plug to fit into a two-pronged outlet! If
the plug will not fit the outlet, have the
proper outlet installed by a qualified
electrician.
Do not discard the packing materials until
you have carefully inspected the tile cutter,
identified all parts, and satisfactorily
operated you new tile cutter.
Water tank
Spanner B
spanner A
riving knife