Preparation; Connecting The Antennas - JVC TH-F3 Instructions Manual

Preparation

Connecting the antennas

AM loop antenna (supplied)
Setting up the AM loop antenna
If insulation covers the tips of the
antenna cable, twist and pull off
the insulation.
NOTE
• Keep the AM loop antenna cable wrapped
around the AM loop antenna frame, otherwise
the effectiveness and sensitivity of the AM loop
antenna may be reduced.
Connecting the AM loop antenna
Main unit (rear view)
Turn the AM loop antenna to find the best position
for radio reception.
NOTE
• Make sure that the antenna conductors do not
touch any other terminals. This could cause poor
reception.
5
Do not connect the power cable until all other connections have been made.
FM antenna (supplied)
Main unit (rear view)
When radio reception with the supplied FM
antenna is poor, or when using a communal
antenna
Main unit (rear view)
Antenna cable
(not supplied)
Converter (not sup-
plied: compatible
with 300 C/75 C)
Depending on the radio reception
conditions, an FM feeder
antenna (not supplied: compati-
ble with 300 C) can be used. In
this case, a converter (not sup-
plied) is required.
• When using an antenna other than those sup-
plied with this system, refer to the operation
manuals for the antenna and converter for
details of connection.
• When positioning the antennas, find the best
position for reception while listening to an actual
radio program (refer to "Listening to radio broad-
casts" on page 15).
• You cannot receive an FM/AM radio broadcast
without the antenna connection.
FM antenna
Stretch out the FM
antenna to the best
position for radio
reception.
Communal
antenna terminal
or
Outdoor FM
antenna
(not supplied)
Coaxial cable
(not supplied)