Accessing & Removing The Electronic Assemblies - Whirlpool W10298850 Technical Data Manual

FOR SERVICE TECHNICIAN ONLY - DO NOT REMOVE OR DESTROY
8. If water is still not dispensed:
Unplug dryer or disconnect power.
Replace the machine control electronics.
ACCESSING & REMOVING THE
ELECTRONIC ASSEMBLIES
There are two electronic assemblies: the Machine
Control Electronics and the Console Electronics
and Housing. See figure 14.
1. Unplug dryer or disconnect power.
2. Remove the three rear screws from the top
panel, and slide the top panel to the rear to remove.
Machine Control
Electronics
Assembly
FRONT
Figure 14. Locate the electronic assemblies.
Machine Control Electronics
1. Perform preceding steps 1 and 2, then remove
the two screws that hold the machine control
electronics bracket in place.
2. Slide the bracket over the top of the drum
to access the machine control electronics
connectors and mounting screw. See figure 15.
Console Electronics
and Housing
Assembly
PAGE 21
Machine Control Electronics
Bracket Screws
Machine Control
Electronics Mounting Screw
Figure 15. Remove machine control
electronics from mounting bracket.
3. Remove all the wire connections to the machine
control electronics. See figure 16, page 22.
4. Remove the screw holding the machine
control electronics assembly to the mounting
bracket. See figure 15.
5. There are two plastic legs on the front of the
machine control electronics that slide under the
mounting bracket.
 There is one plastic leg on the rear of the
machine control electronics that slides under
the mounting bracket.
 There is a locking tab on the bottom of the
machine control electronics that snaps into the
mounting bracket.
Press the locking tab on the bottom of the
machine control electronics and slide the
assembly to the front, then lift.
Console Electronics and Housing Assembly
The console panel must be removed to access
the console electronics and housing assembly.
1. Perform steps 1 and 2 under Accessing &
Removing the Electronic Assemblies, and disconnect
the P2 harness from the machine control.
FRONT