Spin Master Hyper Actives Stunt Instructions

®
INSTRUCTIONS
Contents:
• 1 x Hyper Actives Stunt™
• 1 x Controller/Charger
• 1 x Instruction Guide
WARNING:
CHOKING HAZARD – Small parts.
Not for Children under 3 years.
1. Open the battery door with a
screwdriver (not included).
2. If used batteries are
present, remove these
batteries from the unit by
pulling up on one end of
each battery.
3. Install new batteries as
shown in the polarity
diagram (+/-) inside the
battery compartment.
4. Replace battery door
securely.
5. Check your local laws
and regulations for correct
recycling and/or battery
disposal.
1. Turn vehicle OFF.
2. Turn controller/charger OFF.
3. Open charge door to access
charge cable.
4. Open charge port cover located
on the side of the vehicle.
5. Carefully push the charge plug
all the way into the vehicle s
charge port.
6. Set the controller/charger switch
to CHG.
7. The red charging light will turn
on and charging will begin when
it starts to flash. After 30 to 50
minutes the charging will be
complete and the red charge
light and green power light will
both start to flash.
8. When charging is complete,
turn controller/charger OFF.
9. Carefully remove the
charge plug from the vehicle s
charge port.
10. Close the charge port cover.
11. Wrap charge cable starting
at tab indicated then close
charge door.
NOTE: 1. If the charge light and power light are flashing alternatively while
charging, there may be a bad cable connection. Check that cable and plug
are connected correctly and repeat charging steps 1 to 6.
2. The remote control will automatically shut off after idling for about
Forward/Reverse, Left/Right
1. Turn vehicle ON.
2. Turn controller/charger ON.
3. The left stick controls
the vehicle s forward and
reverse driving.
4. To move the vehicle to the right
push the right stick to the right.
5. To move the vehicle to the left
move the right stick to the left.
ON/OFF
Switch
Over-sized
Tires
Hyper Actives
Stunt™
INSTALLING/REPLACING THE BATTERIES
Compartment
HOW TO CHARGE YOUR HYPER ACTIVES STUNT™
1
4
CHG OFF ON
8
USING THE CONTROLLER/CHARGER
1
4
Charge
Port
Forward/
Reverse
Charge Light
CHG/OFF/ON
Switch
Impact
Bumper
Cover and
Charge Cable
Controller/Charger
Battery
• Controller/charger requires
Cover
6 x 1.5V AA alkaline
batteries (not included).
• Batteries are small objects.
• Replacement of batteries
must be done by adults.
6 x
• Follow the polarity (+/-)
1.5V AA
diagram in the battery
Alkaline
compartment.
Batteries
• Promptly remove dead
batteries from the toy.
• Dispose of used batteries
properly.
• Remove batteries for
prolonged storage.
• Only batteries of the same
or equivalent type as re-
Battery
commended are to be used.
Compartment
• DO NOT incinerate used
CHG OFF ON
2
O
5 6
9
5 minutes. To reactivate turn off and on.
3. When the remote control is in either ON status or CHARGE status and
the green power light is flashing, it means that the battery level is low
and the batteries need to be replaced.
CHG OFF ON
2
TM
Turbo Button
BATTERY SAFETY INFORMATION
batteries.
• DO NOT dispose of
batteries in fire, as batteries
may explode or leak.
• DO NOT mix old and new
batteries.
• DO NOT mix different types
of batteries, i.e.: alkaline/
standard (carbon-zinc) or
rechargeable batteries.
• DO NOT use rechargeable
batteries.
• DO NOT recharge
non-rechargeable batteries.
• DO NOT short-circuit the
supply terminals.
• DO NOT store your car
or controller near heat or in
direct sunlight.
3
CHG OFF ON
7
10 11
3
5
8-10
YRS
Power Light
Spin Button
Left/Right
Trim Knob