Gyro Settings - Spektrum DX10t Instruction Manual

EN
9-6 Swashplate Settings
In this menu you adjust numeric values for Aileron and
Elevator settings. Preset of both setting are +60. When
using the stick, you see the stick movement on the left
side of the display.

9-7 Gyro Settings

The Gyro can be adjusted with numeric settings from
– 100 to + 100 in 0.5 increments.
In the lower part of the display, you can assign the
function to a channel and switch.
9-8 Governor
The Governor function adjusts the engine RPM. You can
program four values with different switches, including the
Flight Mode switch. RPM values can be programmed in
5% Steps. You can also program the channel.
Programming the Governor Function
Press the Roller from the Main or Telemetry display to
access the Function List.
Selecting a Switch
The Governor default setting is inhibited. For activation,
highlight and press the Roller on the deactivated box.
Select a switch for that function.
Assigning an Output Channel
In this menu, you can assign the Governor output
channel. The Governor and Gyro must be on different
channels. Rotate the Roller to the channel box, press the
Roller and select the channel that you want to use for the
Governor. Usually this is Aux 2.
9-9 Tail Mix
Programming of the Tail Mix is similar to Throttle or Pitch
Mixes. You can program four separate mixes or one
mix to two or more flight modes. Graphic information on
the left side shows values that are programmed on the
right side. An Expo function for smoothing the curve is
available.
NOTICE: Only use the tail mix with a conventional Gyro
with no Heading Lock Mode.
Programming the Tail Mix (Revo Mix)
Push the Roller to see the Function List. Select Revo Mix.
Selection of Flight Mode
Select desired Flight Mode. You will see your chose flight
mode in a dark frame.
18
Programming the RPM values
Rotate the Roller to the inbox, press the Roller and rotate
it to the value you want to set.
Please note: The value in the display is the corrected
value. 0% is 1.500ms or OFF for most governors.
Repeat this for all governor settings.
Adjusting the Curve
Switch the Flightmodeswitch into the desired position you
want to adjust. Select the single point of the throttle curve
(Low, 25, 50, 75 High) Press the Rollerbutton for inserting
values.
Change values with turning. Please note the curve
position on the left side of display. Repeat this for all other
points of the curve.
Expo Function
Turn the Roller to the Box EXPO and press for ON or
Inhibited.
SPEKTRUM DX10t • RADIO INSTRUCTION MANUAL