How To Design A System - Lutron Electronics EcoSystem Technical Manual

EcoSystem
Here are the 4 steps to designing an EcoSystem:
Step 1 Ballast Selection
A Determine number of fixtures that will be connected to EcoSystem.
Note: Do not consider control zones, since they will be programmed rather than wired.
B Classify the type of ballast in each fixture.
Note: Use a Ballast Module Fixture-mounted (BMF) in conjunction with a ballast for dimming
down to 1% or for lamp types where EcoSystem is not yet available. A BMF connected
to any Eco-10 or Hi-lume
™
EcoSystem T8 Digital Ballast
pg. 06
EcoSystem Ballast Module Fixture-mounted (BMF)
pg. 07
2
Step Sensor/Receiver Selection
Determine what sensors should be connected to EcoSystem.
Note: EcoSystem ballasts are compatible only with EcoSystem daylight sensors.
EcoSystem Daylight Sensor
with IR Receiver
pg. 08
|
04 Lutron
|

how to design a system

™
ballast gives full EcoSystem functionality to that ballast.
®
EcoSystem T5 Digital Ballast
pg. 06
20VDC Occupancy Sensor
pg. 10
www.lutron.com/ecosystem
EcoSystem IR Receiver
pg. 12
Lutron World Headquarters: 1.610.282.3800