Removing Float Switch; Disconnect The Wire To Wire Float Switch Connector Inside The Unit - Electra DNG 100 Service Manual

14.4.7 Removing Thermistors
1. Disconnect the thermistor connector from the main board.
2. Cut the nylon ties holding the wires to the pipes or chassis.
ICT thermistor only - Pull up the spring from the housing while pulling out the thermistor.
Notes for re-assemble the ICT thermistor:
1. Make sure the spring is inserted first and is facing the tube to be attched to. Hold the thermistor
wires to the tube with nylon tie holding both the wires and the protective sleeve.
Indoor Air Thermistor (RAT)
14.4.8

Removing Float Switch

1. Remove the Service Panel, from fan side
only, according to 14.3.4.
2. Disconnect the wire to wire float switch
connector inside the unit.
3. Cut the nylon ties holding the wires to the
pipes or chassis.
4. Use 2 open spanners to remove the nylon
nuts of the switch and take out the switch.
SM OU12HP 2-E.2 GB
Indoor Coil Thermistor (ICT)
CONTENTS
SERVICING
"O"
14-21