Vertex Standard VX-230 Series Service Manual page 14

Alignment
9. DCS D <W
EVIATION
This parameter is to align "DCS Deviation" of the selected channel.
1. Input the desired DCS Code on the DCS Code Box.
Default: 523
Input Range: 000 to 777
2. Click the "PTT" button, then the radio starts to transmit on
selected channel.
3. Set the value to get desired deviation on the deviation meter
by drag the slide bar, click the up-down button, press the
left or right key, or enter the value on the entry box.
4. After getting the desired deviation then click "PTT" button
to stop the transmit.
5. Click "OK" button to finish the DCS Deviation alignment
and save the data.
ADJ Type
Single : Alignment value change only to selected channel.
All Freq : Alignment value change for connecting with other
channels.
10. B
ATTERY
This parameter is to align the "Alert Reference voltage" and "Write Protect Level" voltage. When the DC source power becomes
below the "Write Protect Level" voltage, the radio will stop writing data to the EEPROM due to prevent the erroneous writing.
1. Set the value of DC Power source to 6.5V (according to the
indication) and click "Start" button. Then alignment value
show in the "New" box.
2. Set the value of DC Power source to 5.5V (according to the
indication) and click "Start" button. Then alignment value
show in the "New" box.
3. Click the "OK" button, then the data will be saved and the
alignment is accomplished.
4. Set the value of DC Power source to 7.5V (according to the
indication).
VX-230 Series UHF FM Transceiver Service Manual
> / <N >
IDE ARROW
14