Table of Contents
Advertisement
Operation
Once all equipments are powered on, it is shown by the blue link LED (refer to below
table). Then system will initiate a wireless link, successful connection of the link will
be shown by the blue link LED (refer to below table). This may take short time
depending on the distance between the units and other environmental factors.
When the initial wireless link has been established, the system will establish a video
link between the transmitter and receiver. Once it has been completed, the blue
video LED will be lit on both units (refer to below table *). If your HDMI source and
display devices support CEC then your source device can simply to control using the
displayer remote controller.
LED STATUS
Link LED slow flicker
Link LED fast flicker
Link LED lighting
Remote controller operation
MENU
Enter to setup mode
EXIT
Exit setup mode
SOURCE
Wireless transmitter source list
ADD
Searching and adding a new
wireless transmitter
DELETE
Delete a wireless transmitter
OK
Confirm key
1 2 3
Change to source 1 2 3
Move cursor
CAUTION: Remove the paper from battery room please when you use controller first
time.
Use enclosed remote controller to search and add a new transmitter to delete a
transmitter. Use your remote controller point to transmitter.
MEANING
Power on
Establishing link
Established link
4
Advertisement
Table of Contents
