Contents 1. Product Introduction........................1 2. Main Functions..........................1 3. Specification..........................1 4. Equipment operation and function description................1 5 Troubleshooting..........................4 Frequent Asked Questions......................4 6. Package List............................5 7.Version And Manufacture Information.................... 5 Safety Reminder To protect the equipment and operating personnel from electrostatic discharge, you should check and ensure it is properly grounded before powering on.
Page 3
Ensure equipment is properly grounded Please use single-phase three wire system AC 220V power supply, and ensure all transmission system is properly grounded. For the safety of operating personnel and the equipment, please turn off all power supplies and remove the plug before moving or performing physical task.
With this enhanced model ends with the “P”, meaning that only required a single power supply from either the transmitter or at the receiver end. CAT-HDMI-70CT-P & CAT-HDMI-70CR-P comprises of two parts, a transmitter and a receiver, CAT-HDMI-70CT-P transmitter, converts the HDMI signal into a single cable transmission. CAT-HDMI-70CR-P, the receiver, manages and converts the high-definition network signal back to HDMI signal.
Page 5
2.Use cable to connect transmitter and receiver. 3.Connect the display device at the transmitter output; 4.Power the device (DC12-24V); Device panel description Figure 4.2.1 CAT-HDMI-70CT-P transmitter front and rear panel 1,RS232 and IR signal port 2,HDMI signal input port 3, power connector...
Page 6
Figure 4.2.2 CAT-HDMI-70CR-P Receiver Front and Rear Panels 1,RS232 and IR signal port 2,HDMI signal output port 3, power connector 4, RJ45 port (network signal output) Figure 4.2.3 CAT-DVI-70CT-P transmitter front and rear panel 1, Power connector 2,RJ45 port (network signal output)
3, RS232 and R port 4,DVI signal input port Figure 4.2.4 CAT-DVI-70CR-P Receiver Front and Rear Panels 1, Power interface 2,RJ45 port (network signal output) 1、RS232 and IR signal output 2、DVI signal output 4.3 Indicator light description POWER: power indicator light, turn on the power after the light MODE: device operating status indicator, blinking indicates that the device is operating normally LINK: HDbaseT signal connection indicator, the device with a cable connected to a constant light HDCP:HDCP: signal output indicator, blinking signal output is normal...
Please check power adaptor or signal cable for loose connection. Turn off the equipment and wait for 5 seconds before restarting. This is because the product contains a high speed DDR, that will take about 5 seconds to completely reboot. b.
Page 9
Contact us Kensence (shenzhen) Technology Development Address : Rm301-310 Tangtou blvd ,shixin community ,shiyan Town , Baoan District , shenzhen ,China 518108 Fax : 86-0755-29377262 Website : www.kensence.com Mail : Service@kensence.com...