Engine Installation - Honda HPD L15A7 Installation Manual

Swift Chassis DB-1 & DB-6
L15A7 Engine Installation Manual

Engine Installation

Install the lower rear mounting studs.
This engine will install in the same
manner as your previous engine.
Be sure the water lines are installed
on the engine per the engine race kit
manual.
Install the gearbox adaptor with the
supplied dowels and socket head
bolts to the bell housing.
The spacers in the chassis for the
lower front mounting studs need to be
a minimum length of 30mm, to
prevent the flange nut from bottoming
on the shank of the stud. (1.18").
Four 3mm thick washers are included
in the kit to help adjust this dimension.
If needed, they are to be placed
between the flange nut and frame
member, indicated by the arrow.
17
8/2010