Introduction; Use The Ecl Comfort 310 In Scada Systems Via Wlan; What Is A Wireless Brigde; System Overview - Danfoss ECL Comfort 310 Installation Manual

Installation Guide

2.0 Introduction

2.1 Use the ECL Comfort 310 in SCADA systems via WLAN

The ECL Comfort 310 controller has a built-in ethernet interface which
enables it to connect to the local network (LAN) via a standard
ethernet cable.
By connecting the ECL Comfort 310 to the local network and/or the
internet the ECL Comfort 310 can be used in SCADA systems like the
Danfoss ECL Portal.

2.2 What is a wireless brigde?

The function of the wireless bridge is to be a bridge between a
wireless network (WLAN) and an ethernet network (LAN).

3.0 System overview

3.1 Components

The components of interest are shown in the picture below.
A new or existing wireless internet connection (WLAN) is made
available by the wireless internet router in the building.
Wireless internet router
2
DEN-SMT/DK
ECL 310 Comfort to WLAN
Wireless bridge
(Netgear WN3000RP)
VI.HX.D1.02
In some installations it may be prefered to use wireless network
(WLAN) instead. In such cases the ECL Comfort 310 can easily connect
to a wireless network by using a wireless bridge.
By using a wireless bridge a device like the ECL Comfort 310 can
connect to the wireless network and/or the internet using its
standard ethernet interface.
A wireless bridge is added to the heating installation and the ECL
Comfort 310 is connected to the wireless bridge using a standard
ethernet cable.
ECL Comfort 310
Danfoss District Energy