Front Panel Description (C-Series) - Nirvana B50 Installation Instructions Manual

9.2 FRONT PANEL DESCRIPTION (C‐SERIES)
1 Displays the current temperature of the water.
2 Button 'SET' which is used to move through menus
3 Button 'INCREASE' which is used to increase the temperature of water
4 Button `DECREASE' which is used to decrease the temperature of water
5 The yellow light means we are in the POOL mode
6 Means we are in HEATING mode
7 Means the compressor is running
The pump will go on and then the current water temperature will be displayed.
The current temperature displayed is kept in memory and displayed for 5 minutes until the water temperature sensor
has sampled the circulating water. After 5 minutes, the water temperature is automatically updated and displayed.
ADJUSTING DESIRED TEMPERATURE (B,C &E‐SERIES)
Settings:
Pool
SPA option
The control is shipped set to OFF in POOL and SPA mode. (option)
The heat pump stops automatically if a setting below 61° F / 16°C is selected.
In OFF mode, the control will display the water temperature.
Use the SET key to select POOL or SPA mode.
Use the ↑ key to increase the desired setting to above 61° F / 16°C.
The heat pump compressor operates automatically if a setting above 61° F / 16° C is selected.
Adjust the settings to the desired value.
OFF, 61° F à 95° F
OFF, 61° F à 104° F
WARNING
OFF, 16° C à 35° C
OFF, 16° C à 40°C
18