Table of Contents
Advertisement
Chapter 2
Installing Internal Peripherals
After installing the CPU, Fan/Heatsink, and memory
modules, you can install internal peripherals such as a
hard disk drive (IDE/HDD), and CD-ROM drive. You
may have to set the jumpers of each internal peripheral to
either Master or Slave mode depending on whether you
install more than one peripheral.
Important: Make sure the 110/220 switch on the back
Installing an IDE drive
To install an IDE drive:
1 Set the required jumpers on the IDE drive according to
the instructions of the manufacturer.
2 Remove the 3-connector peripherals cable from the
accessories box and attach it to the blue connector
IDE1 on the motherboard.
3 Bring the cable up and over the IDE drive and attach
the cable's middle connector to the IDE drive. With the
cable wrapped over the top of the IDE drive, slide the
drive into the lower chassis port.
Important: The IDE cable must be wrapped over the IDE
4. Secure the IDE drive to the chassis port by inserting
mounting screws in all the holes and tightening these
screws with a screwdriver.
5. Connect an available power cable from the power
supply unit to the back panel of the IDE Drive. Note
that the power cable is directional and can only fit one
way.
User's Manual
panel is set to the appropriate voltage.
Drive to keep it from blocking the fan.
Installation
2 - 9
Advertisement
Table of Contents
