Disposal; Manufacturer's Warranty - Hilti DCH 300 Operating Instructions Manual

Fault
The power tool doesn't start.
en
The power tool doesn't achieve
full power.
The power tool doesn't start
and the service indicator blinks
red.
The power tool doesn't start
and the service indicator lights
red.
The power tool doesn't start
and the theft protection system
indicator blinks yellow.

10. Disposal

Most of the materials from which Hilti machines or appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, Hilti has already made
arrangements for taking back old machines and appliances for recycling. Ask Hilti customer service or your
Hilti representative for further information.
For EC countries only
Disposal of electric appliances together with household waste is not permissible.
In observance of European Directive 2002/96/EC on waste electrical and electronic equipment and
its implementation in accordance with national law, electric appliances that have reached the end
of their life must be collected separately and returned to an environmentally compatible recycling
facility.

11. Manufacturer's warranty

Hilti warrants that the tool supplied is free of defects
in material and workmanship. This warranty is valid
so long as the tool is operated and handled correctly,
cleaned and serviced properly and in accordance with
the Hilti Operating Instructions, and the technical
system is maintained. This means that only original
Hilti consumables, components and spare parts may
be used in the tool.
34
Possible cause
Other electrical fault.
The electronic restart interlock is
activated after an interruption in the
electric supply.
The extension cord's conductor
cross section is inadequate.
A fault has occurred in the power
tool.
The carbon brushes are worn.
The power tool has not been
unlocked (tools with optional theft
protection system).
This warranty provides the free‐of‐charge repair or
replacement of defective parts only over the entire
lifespan of the tool. Parts requiring repair or replace-
ment as a result of normal wear and tear are not
covered by this warranty.
Additional claims are excluded, unless stringent na-
tional rules prohibit such exclusion. In particular,
Remedy
Have it checked by a trained
electrical specialist.
Switch the power tool off and on
again.
Use an extension cord with an
adequate conductor cross section.
(Please refer to "Before use".)
If necessary, the power tool should
be repaired by Hilti Service.
Have checked by a trained electrical
specialist and replaced if necessary.
Use the TPS key to unlock the power
tool.