Heat & Glo GRAND-I35 Owner's Manual page 34

G. Install the Log Assembly
Log Set Assembly: LOGS-I30
Models: Supreme-I30, Supreme-I30-SP, Supreme-I30AU
CAUTION: Logs are fragile, handle with care.
LOG SUPPORT LOG SUPPORT
PILOT PILOT
BRACKET BRACKET
LEFT LEFT
GRATE TINE GRATE TINE
Figure 1.
Log #1 (SRV2206-701) Position Log #1 as shown in Figure 2. Note additional placement instructions in Figure 1 and Figure 3. The
left end of the log should rest on the log support. Slide the log to the rear until it stops against the edge of the refractory support.
See Figure 3. Rest the right end of the log on the horizontal portion of the right grate tine. Rotate the right end of the log clockwise,
until it touches the vertical portion of the right grate tine.
FRONT EDGE OF REFRACTORY FRONT EDGE OF REFRACTORY
SUPPORT CONTACTS THIS LINE SUPPORT CONTACTS THIS LINE
SURFACE RESTS ON SURFACE RESTS ON
REFRACTORY SUPPORT REFRACTORY SUPPORT
Figure 3. Log #1
Log #2 (SRV2206-705): Position Log #2 as shown in Figure 4. Refer to Figure 1 and Figure 5 for additional details. Mate
the slot located on the bottom of Log #2 with the log pin located on the surface of the burner. Rotate the right end of Log #2
clockwise, until it comes into contact with the grate tine.
34 Heat & Glo • Grand-I35, Grand-I35-SP, Supreme-I30, Supreme-I30-SP • 2206-900 Rev. C • 8/10
LOG PIN LOG PIN
RIGHT RIGHT
GRATE TINE GRATE TINE
BASE OF BASE OF
GRATE TINE GRATE TINE
CONTACTS CONTACTS
THIS LINE THIS LINE
SRV2206-706 SRV2206-706
SRV2206-703 SRV2206-703
SRV2206-701 SRV2206-701
LOG LOG
SUPPORT SUPPORT
2205-935
LOG CONTACTS LOG CONTACTS
BURNER TOP BURNER TOP
Figure 2. Install Log #1
FLAT FLAT
SPOTS SPOTS
FOR LOG FOR LOG
#4 #4
2 2
MATE SLOT WITH MATE SLOT WITH
LOG PIN LOG PIN
Figure 4. Place Log #2
SRV2206-705 SRV2206-705
SRV2206-704 SRV2206-704
SRV2206-702 SRV2206-702
1 1
LOG RESTS ON LOG RESTS ON
GRATE TINE GRATE TINE
FLAT SPOTS FLAT SPOTS
FOR LOG #5 FOR LOG #5
GRATE TINE FITS GRATE TINE FITS
IN LOG GROOVE IN LOG GROOVE