Heat & Glo GRAND-I35 Owner's Manual page 32

FLAT SPOT FOR LOG #4 AND LOG #7 FLAT SPOT FOR LOG #4 AND LOG #7
LOG FOOT LOG FOOT
CONTACTS CONTACTS
LOG SUPPORT LOG SUPPORT
Figure 5. Log #2
Log #2 (SRV2205-701): Position Log #2 as shown in Figure 5. Refer to Figure 2 and Figure 6 for additional details. Mate
the right grate tine with the log groove. Rest the back of the log on the log support. Rotate the back of the log clockwise
until the foot contacts the vertical wall of the log support.
LOG GROOVE LOG GROOVE
CONTACTS CONTACTS
GRATE TINE GRATE TINE
Figure 7. Log #3
Log #3 (SRV2205-705): See Figures 2, 7 and 8 for reference details. Position the grate tine with the groove located on the
side of the log. Rotate the right end of the log clockwise until the end of the log contacts the grate bar.
FLAT SPOT FOR FLAT SPOT FOR
LOG #6 LOG #6
LOG GROOVE LOG GROOVE
CONTACTS CONTACTS
GRATE TINE GRATE TINE
Figure 9. Place Log #4
Log #4 (SRV2205-704): See Figures 2, 5, 7 and 9 for reference details. Position Log #4 so that the log groove contacts
the grate tine as shown in Figure 9. Set the other end of the log on the fl at spot located on Log #2. See Figure 5.
Log #5 (SRV2205-710): See Figures 2, 3 and Figure 10 for reference details. Mate the notch on Log #5 with the grate tine
as shown in Figure 10. Set the other end of the log on the fl at spot of Log #1.
32 Heat & Glo • Grand-I35, Grand-I35-SP, Supreme-I30, Supreme-I30-SP • 2206-900 Rev. C • 8/10
2
MATE TINE WITH MATE TINE WITH
LOG GROOVE LOG GROOVE
FLAT SPOT FLAT SPOT
FOR LOG#4 FOR LOG#4
3
LOG CONTACTS LOG CONTACTS
GRATE BAR GRATE BAR
END OF LOG RESTS END OF LOG RESTS
ON FLAT SPOT ON FLAT SPOT
4
POINT OF LOG RESTS POINT OF LOG RESTS
ON FLAT SPOT ON FLAT SPOT
SURFACE SURFACE
CONTACTS CONTACTS
LOG SUPPORT LOG SUPPORT
Figure 6. Log #2
LOG GROOVE LOG GROOVE
Figure 8. Log #3
LOG RESTS ON LOG RESTS ON
FLAT SPOT FLAT SPOT
LOG NOTCH LOG NOTCH
CONTACTS CONTACTS
GRATE TINE GRATE TINE
Figure 10. Place Log #5
LOG FOOT LOG FOOT
FLAT SPOT FOR FLAT SPOT FOR
GRATE BAR GRATE BAR
5