First-Time Use; Unpacking; Inserting The Battery Into The Receiver; Charging The Battery For The First Time - ashtech MobileMapper 100 Getting Started Manual

First-Time Use

Unpacking

Inserting the
Battery Into the
Receiver
Charging the
Battery for the First
Time
Open the receiver box and unpack the following items:
• Receiver
• Battery
• Docking station
• Universal AC adapter
• USB cable
Follow the instructions below:
• Turn over the receiver and rotate the finger screw counter-
clockwise a quarter turn and pull the trap door open.
• Insert the battery as shown. The label must be outwards
and the right way up.
• Put the trap door back into place by first inserting the two
clips located at the top of the trap door.
• Then push the door against the case and rotate the finger
screw clockwise by one-quarter turn for a secure and
sealed closure.
The fastest way to charge the battery before first use is to
keep the receiver off until the battery is charged. In these
conditions, it will take less than 4 hours to fully charge the
battery. Follow the instructions below.
• Prepare the AC adapter:
1