Table of Contents
Advertisement
Connecting the base station
¤
First connect the mains adapter
¤
Then connect the telephone jack
cable ducts.
Please note:
◆
The mains adapter must always be connected, as the phone will
not operate without mains connection.
◆
Use only the mains adapter and phone cord supplied. Pin connec-
tions on telephone cables can vary.
Connecting the charging cradle (if included)
2
1
Setting up the handset for use
The display is protected by a plastic film. Please remove the protective film!
Inserting the batteries and closing the battery cover
Warning
Use only the rechargeable batteries recommended by Gigaset Communications GmbH (
conventional (non-rechargeable) batteries as this could result in significant health risks and personal injury. For
example, the batteries could explode. The phone could also malfunction or be damaged as a result of using batteries
that are not of the recommended type.
¤
Insert the batteries with the polarity in
the correct direction.
The polarity is indicated in the battery
compartment.
Initial charging and discharging of the batteries
The correct charge status can only be displayed if the batteries are first fully charged and discharged.
1
.
2
and insert the cables into the
¤
Connect the flat plug to the power
1
supply
.
¤
Plug the mains adapter into the plug
2
socket
.
¤
Charge the handset in the base for 6.5 hours.
6.5
h
The handset must only be placed in the designated Gigaset base or
charging cradle.
¤
After charging, remove the handset from the base and only replace it
when the batteries are fully discharged.
3
If you need to disconnect the plug
from the charging cradle, press the
3
release button
4
the plug
.
¤
First insert the battery cover at the top a.
¤
Then press the cover
¤
To reopen the battery cover, grip into the cavity on the
casing, then pull the battery cover in an upward direc-
tion.
Please note
2
1
and disconnect
¢
page 9), i.e. never use
b
until it clicks into place.
a
1
1
4
3
b
Hide quick links:
Advertisement
Table of Contents
