Advertisement
Installing the Custom-Shape Wireless Dog Fence
To attach using the removable wall-mount adhesive strips:
• Clean the surface of the desired location of the Base with isopropyl
rubbing alcohol, wipe gently with a soft cloth and let dry. DO NOT
USE household cleaners (see Figure 1.0).
• Separate strips (if still connected) at the perforation.
• Peel the liner from the back of one of the strips and attach it
vertically to the middle of the Base with the release-tab pointed
upward toward the antennas (see Figure 1.1a).
• Connect another strip to the strip on the Base by pressing the
fasteners of both strips firmly together until they snap. The
release-tab on the other strip should point downward away
from the antennas - the opposite direction of the release-tab of
the strip on the Base (see Figure 1.1b).
• Peel the liner from the back of the other strip and attach it to the
wall with the release-tab facing downward toward the floor and
the Base antennas facing upward toward the ceiling (see Figure 1.2).
To remove the adhesive strips:
• Pull the Base gently from the wall by disconnecting the fasteners.
DO NOT pull the strips off the Base or the wall.
• Start with the strip on the wall. Press one hand on the end of the
strip opposite the release-tab and use your other hand to pull
the release-tab slowly straight down against the wall, stretching it
at least 12 inches until the strip releases. Repeat for the strip
attached to the Base (see Figures 1.3a & b).
NOTE: The removable wall-mount adhesive strips are not
recommended for wallpaper. Apply to surfaces above 50˚F .
Adhesive could soften and lose adhesion above 105˚F.
®
Havahart
Custom-Shape Wireless Dog Fence
9
www.HavahartWireless.com
Figure 1.0
Figure 1.1a
Figure 1.1b
Figure 1.2
Screen 1.2
Figure 1.3a
Figure 1.3b
Accessing the Wireless Fence Tracker:
The Wireless Fence Tracker program allows you to see approximately
where your wireless Fence Boundary lies and where your dog is and has
been in relation to your Base locations. Your home computer will need
internet access in order to operate the program.
1.
Make sure the computer is located within 6 feet of the Master Base A.
2.
To access the Wireless Fence Tracker, visit
www.HavahartWireless.com/myaccount.
3.
If you don't have an account, create one to gain secure access to
the program.
4.
The Wireless Fence Tracker Grid should appear with 4 Bases on the
screen (see Figure 2.3). At this time, these Bases do not yet
represent your Bases.
5.
Disconnect the fully charged Controller from the USB cable.
6.
Connect your computer to the Master Base A via the USB cable.
Figure 2.0
®
Havahart
Custom-Shape Wireless Dog Fence
10
1-800-800-1819, Option 1
Advertisement
